AES E-LOOP Door Access Controller EXIT MODE Commercial Kit

AES EL00C-K E-LOOP Door Access Controller EXIT MODE Commercial Kit

The Commercial Wireless Vehicle Detection System uses magnetometer sensors to detect the presence of oncoming vehicles. These detections are transmitted to a nearby transceiver for gate activation. After the vehicle is detected, the e-loop will switch to radar mode. The sensors are installed on the surface of entry or exit passages using concrete fixing bolts, contain four replaceable Lithium batteries, and can withstand almost any vehicle.

Note: Gate or door controller must have a dedicated open input and auto close function enabled.

Both e-loop models are available in two modes: PRESENCE MODE WITH ADDED RADAR PROTECTION OR EXIT MODE.

Installation in 3 simple steps:

• 1. Code in the e-Loop
• 2. Secure the e-Loop to the driveway
• 3. Calibrate the e-Loop... and youÕre ready to operate in less than 15 minutes

This Kit Includes:

• 1 x e-Loop Exit mode
• 1 x e-Trans 50 (transceiver)
• 2 x Concrete fixing bolts
• 1 x Magnet

Features:

• Fast and simple installation (quick non-permanent installation)
• Not effected by ground movement
• Range up to 50 metres/yards
• Exit Mode
• Commercial E-loop Surface Mounted
• Lower power consumption: 3-axis magnetometer for vehicle detection
• Compact design
• Compatible with various gates
• Reliable radio communications with transceiver

Technical Specifications:

• 8 Hz sampling rate
• Auto-calibration
• Exit/Entry detection mode
• 10600 mA battery (included) giving up to 6-10 years battery life (depending on mode).
• Made of high-impact plastic (10 tonne static load limit)
• High security 128-bit encryption
• IP rating: IP68

Dimensions:

• 220 x 220 x 28 (mm)